Table of Contents
Advertisement
t
The 'Program' symbol is flashing
Press the 'Menu'
does not require any changes, so this menu will jump to Step 5.
Use the
battery. Check the range for this value in the section 15 ('Specifications').
Press the 'Enter'
Use the
battery. Check the range for this value in the section 15 ('Specifications').
Press the 'Enter'
and this menu will jump to Step 5.
Note The loat voltage has to be set to at least 0. V below the Bulk Voltage setting.
The unit blocks changes invalid ones (see notes in section 5 Specifications ).
t
t
The Disconnect Voltage Setting and the symbol
Press the 'Menu'
changes, so this menu will jump to Step 6.
Use the
range for this value in the section 15 ('Specifications').
Press the 'Enter'
setting, and this menu will jump to the Reconnect Voltage setting with the symbol
Use the
for this value in the section 15 ('Specifications').
Press the 'Enter'
setting, and this menu will jump to Step 6
Note The econnect Voltage has to be set to at least 0.5V above the Bulk Voltage
setting. The unit blocks changes invalid ones (see notes in section 5 Specifications ).
tt
t
tt n
pushbutton if the voltage setting on the 'Program' battery
pushbuttons to adjust the Bulk voltage
pushbutton once to set/confirm the max. Bulk voltage
pushbuttons to adjust the Float voltage setting for the 'Program'
pushbutton once to set/confirm the Float voltage setting,
n s
s
nn t n
buttons to adjust the Disconnect Voltage setting. Check the
flashing.
buttons to adjust the Reconnect Voltage setting. Check the range
nn t
pushbutton if the Disconnect setting does not require any
pushbutton once to set/confirm the Disconnect Voltage
pushbutton once to set/confirm the Disconnect Voltage
Page 13 of 21
setting for the 'Program'
t
tt n s
are shown on the display
.
Advertisement
Table of Contents
