Table of Contents
Advertisement
t
t
The 'C00' or 'C01' setting will be shown on the display to indicate that the three DC-
Load port timers are disabled or enabled respectively
Press the 'Menu'
so this menu will jump back to Step 1.
Use the
OR
ON/OFF) and 'C01' (Automatic ON/OFF by the timers).
Press the 'Enter'
With the 'C00' Manual-only ON/OFF setting, this menu will jump back to step 1
and all the three clock timers will be turned OFF and disabled but keeping their
settings.
With 'C01' Automatic ON/OFF with the timers setting, this menu will start
showing the first timer ON time with the
one-pulse pattern to indicate that the display is showing the corresponding value
for timer 1.
Use the same procedure as setting the Real Time Clock in step 1, by using the
timer 1 when the
Then Press the 'Enter'
ON and OFF time for timer 1, and this menu will repeat the process for timer 2,
and then for timer 3, with their corresponding
flashing periodically with a 2 and 3 pulses pattern respectively.
After setting all the three timers, this menu will jump back to Step 1.
Notes: a) The periodic pulse patterns of the N and
are very useful to indicate what timer the time value being shown and edited on the
display belongs to. b) To disable whatever one or two of the three clock timers, just
set the N time to be the same as the
corresponding timer or timers.
changing their corresponding N
See more details in the section
ork .
n s
pushbutton if this setting does not require any changes,
buttons to swap the setting between 'C00' (Manual-only
pushbutton once to set/confirm the setting
and the "Enter'
Page 14 of 21
s n
n
s
symbol flashing periodically with a
pushbuttons, and follow with the OFF time of the
symbol is shown.
pushbutton once to set/confirm the setting of the
time (with whatever value) in the
c) To disable all the three timers together without
settings, changes to the C00 (manual) setting.
Understanding How the DC-Load port Timers
n
and
symbols
alarm-clock-type symbols
Advertisement
Table of Contents
