Adjustment; Legrest; Tilt Function; Accessories - Etac Swift Mobil-2 Series Manual

Adjustment

Height
G1-G7. The height is easily adjusted by inserting the bolt in
the required position. See distances in the technical
data section.
Arm supports
G8. The height of the arm supports and/or width between the arm supports can be adjusted. Loosen the screws, twist the
support to the desired position and retighten the screws. Then loosen and refit the arm support plate in the correct
position.
Tilt angle
G9. Fit the gas piston in position A to tilt the seat at angles from -5° to 30°
G10. Fit the gas piston in position B to tilt the seat at angles from 0° to 35°
User brake
G11. When adjusting the brake, the brake pin should be set 18 to 22 mm from the rear wheel for good grip.
Leg support
H1. The assistant can easily raise and swivel the leg supports
to the side for the user to sit down in or get up out of
the chair. The foot supports are detachable.

Tilt function

I1. The assistant can adjust the sitting angle with ease by holding in the handle and tilting to the required position.
Make sure that the wheels are locked if the tilt function is used when the user is sitting in the chair.

Accessories

In the section "Accessories", you can see all accessory options available for your product. Variations may occur in different
markets. There are restrictions on accessory combinations, for more information, see www.etac.com.
See Figure J
J1.
Leg and calf rest, angle-variable
J2.
Footrest
J3. Angle adj. footrest
J4. Amputee legrest
J5. Commode pan
J6. Pan-holder attachments
J7. Attachments for low pan-holder mounting
J8. Commode pan holders
J9. Bucket holders
J10. Pan
J11. Lid with handle
J12. Splash guard
J13. Soft Comfort seat, 2 cm high, open at back
J14. Soft Comfort seat, 4 cm high, open at back
J15. Comfort seat
J16. Soft Comfort seat
J17. Soft Comfort seat - narrow opening
J18. ROHO pressure-relieving cushion
J19. Soft cushion - standard opening
J20. Soft cushion - oval opening
English
Check that both sides have been adjusted to the same
height as otherwise stability can be reduced. G7. Do
not use the chair if the bolt (orange) is not locked.
H2. Various height adjustment options are available by mov-
ing the locking pin. The leg supports have 6 different
height settings.
See Figure J
J21. Seat cover
J22. Soft back pad
J23. Comfort padding
J24. Armrest cushion, pair
J25. Trunk support
J26. Chest belt
J26. Positioning belt
J27. Crossbar 605 mm
J28. Crossbar 665 mm
J29. Anti-tip stabilisers including bracket
J30. Anti-tip stabilisers excluding bracket
J31. Tilter
J32. Rear wheel kit
J33. Headrest and bracket
J34. Heel straps
J35. Hemiplegic armrest
J36. Armrest lock
J37. Extended back support
J38. Short leg support
19
Etac / Swift Mobil / www.etac.com
See Figure G
See Figure H
See Figure I
See Figure J