CommScope NG4access Installation Instructions

TECP-90-720 • Rev D • December 2019
NG4access ODF Platform Value-Added Module (VAM)

Installing a Single Height VAM

Install the module from the rear of the universal chassis ("left" module on left side, "right"
module on right side). Use the following procedure, referring to the illustration below.
1. Pull out the access tray handle.
2. Snap the module down in locations 1, 2, and 3, as shown in
module and access tray crossbar at location 4 and 5, as shown, until the module snaps in.
3. Slide in the access tray handle to close the access tray.
4. Connect cables to the module front ports and route the cables on the front of the frame per
instructions on laminated cards hanging on front of the frame (TECP-90-705).
M
N
ACCESS
TRAY
O
HANDLE
P
Q
R
T
U
V
W
X

Installing a Double or Triple Height VAM

Install the module from the rear of the universal chassis ("left" module on left side, "right"
module on right side). Use the following procedure, referring to the illustration below.
1. Identify the two or three trays where the double or triple high VAM is to be installed.
2. Remove the top one or two trays (see instruction video: https://youtu.be/xRx4xUo2fkA).
300100105359 Rev D
This product is covered by one or more U.S.patents or their foreign equivalents.
For patents, see https://www.commscope.com/ProductPatent/ProductPatent.aspx
All Front Access
1
2
4
5
Figure 1. Installing a Single Height VAM
Installation
Instructions
Figure
3
25239-A
1, then squeeze the
Page 1
© 2019 CommScope.
All Rights Reserved.