LED Aircone DMX
LED Aircone
Address Value:
Unit 1
Unit 2
Unit 3
Unit 4
05) Link the units as shown in Fig. 03, connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. You can
use the same functions on the master device as described on page 7+8 (Built-in or Sound-
controlled). This means on the master device you can set your desired operation Mode and all slave
devices will react the same as the master device.
06) Supply electric power: Plug electric mains power cords into each unit's IEC socket, then plug the
other end of the mains power cord into proper electric power supply sockets, starting with the first
unit. Do not supply power before the whole system is set up and connected properly.
Multiple LED Aircones DMX Set Up
Ordercode: 40312
DMX Dip Switches "ON"
1
7
13
19
Note: Link all cables before connecting electric power
9
Fig. 03