Taylor C300 Operator's Manual page 44

TROUBLESHOOTING GUIDE
Problem
8. Leakage from
rear drip pan(s)
into front drip
tray.
9. Excessive mix
leakage from
door spout.
10. Unable to adjust
brix.
11. Lack of syrup
being supplied
to machine.
8
8-2
Probable cause
a. Seal or O-ring on drive shaft is
worn, missing, or incorrectly
installed.
b. Worn rear shell bearing.
a. Inadequate lubrication of draw
valve O-rings.
b. Wrong type lubricant on draw
valve O-rings.
c. Worn or missing draw valve O-
rings.
a. Syrup lines need to be cleaned
and sanitized.
b. Blocked flow control.
a. Loss of CO to propel syrup.
2
b. Clogged or kinked syrup lines.
Remedy
a. Replace or install correctly on
drive shaft.
b. Contact a service technician.
a. Lubricate properly.
b. Use food grade lubricant
(example: Taylor Lube HP).
c. Replace or install O-rings on
draw valve.
a. Clean and sanitize syrup lines.
b. Contact a service technician.
a. Contact a service technician.
b. Sanitize syrup lines regularly. If
kinked, repair or replace.
Model C300
Page ref
6-1
- - -
6-3
6-1
6-3 / 9-1
- - -
- - -
- - -
- - -
Troubleshooting Guide