Taylor C300 Operator's Manual page 28

OPERATING PROCEDURES
2. Lubricate the inside diameter of the drive shaft seal.
Install the drive shaft seal bushing in the drive shaft
seal.
Note: The drive shaft bushing must be positioned in the
center of the drive shaft seal.
3. Slide the seal and bushing over the shaft and groove
until it snaps into place. Fill the inside portion of the
seal with more lubricant and evenly lubricate the end
of the seal that fits onto the rear shell bearing.
6
4. Insert the beater drive shaft into the freezing cylinder,
hex end first, and into the rear shell bearing until the
seal fits securely over the rear shell bearing. Be
certain the drive shaft fits into the drive coupling
without binding. Remove any excess lubricant from
the seal.
6-2
Figure 6-2
Figure 6-3
11387
5. Install the beater assembly. First check the scraper
blades for any nicks or signs of wear. If any nicks are
present or if the blade is worn, replace both blades. If
the blades are in good condition, place the scraper
blades over the holding pins on the beater.
Note: Each hole on the scraper blade must fit securely
over each pin.
11506
6. Align the flats on the end of the beater assembly with
the drive shaft. Make sure the beater assembly
locating pin is in position in the locating hole of the
drive shaft. Turn the beater slightly to be certain that
the beater is properly seated. When in position, the
beater will be approximately 3/8 in. inside the front of
the freezing cylinder.
Important! Ensure the beater is properly seated. Failure
to properly seat the beater may cause damage to the
beater and the door.
Model C300
Figure 6-4
Figure 6-5
Operating Procedures
11507
11112