Table of Contents
Advertisement
PLAYBACK MENU
When you start the VCR AUTO mode the Motion Analyzer will go
through the following steps:
1. The Processor will make a recording.
2. Stop when the recording is complete.
3. Place the VCR in record.
4. Playback the pictures captured in memory as the
VCR records them.
5. Stop the VCR when the playback is complete.
6. The Processor then starts a new recording.
This cycle will repeat until the VCR runs out of tape or a STOP key is
pressed. The Processor will not release the machine to the operator
until it completes downloading the latest pictures to the VCR.
The tape in the VCR will hold a permanent record of every recording
made by the Motion Analyzer while the AUTO mode was in effect.
Press the VCR COPY softkey
and then press any arrow key
to start the VCR copy process.
Pressing any arrow key or a
STOP key will turn VCR COPY
OFF .
VCR COPY automatically downloads the pictures currently in
memory to a VCR using the infrared control link to operate the
VCR. When the playback is complete the Processor will stop the
VCR, turn VCR COPY OFF and return control of the Motion
Analyzer to the operator.
PLAY
VCR
ON
COPY
5.31
Advertisement
Table of Contents
