Table of Contents
Advertisement
ACCESSORIES
IMAGER REMOTE RECORD/STOP
The RECORD/STOP connector on the bottom of the Imager
allows you to start and/or stop a recording remotely. A mating
connector is supplied with the Imager or a replacement can be
ordered using our Part Number 03100075-301. The solder side
of the mating connector is shown below.
HIGH GAIN
RECORD
Wiring the RECORD/STOP connector.
The RECORD/STOP connector pin out is:
1 = RECORD
2 = GROUND
3 = STOP
The RECORD pin and the STOP pin supply +5 Volts DC at
approximately 100 micro-amperes.
The GROUND pin can be connected to the RECORD pin OR the
STOP pin with a dry contact switch closure or an electronic
circuit capable of sinking 300 micro-amperes.
8.2
NORMAL
STOP
Record / Stop Connector
2
3
1
Advertisement
Table of Contents
