Table of Contents
Advertisement
PLAYBACK MENU
RET
X:=105
POS Y :=162
The RET POS softkey window and the DATA-FRAME Border
display the current X and Y coordinates relative to the reference
mark.
The right and left arrow move the vertical line right and left.
The up and down arrow move the horizontal line up and down.
Each quick press of an arrow key causes the Reticle to move one
pixel. When an arrow key is held down for a longer time, the
Reticle will begin to move faster and faster. The maximum Reticle
movement is 16 pixels at a time and is achieved by holding down
an arrow key for approximately 1 second.
The RETICLE is formed by intersecting horizontal and vertical
lines, both lines are one pixel wide. The X and Y coordinates for
the reticle intersection, relative to the reference mark, are dis-
played in the X and Y fields in the DATA-FRAME Border and in the
RET POS (reticle position) softkey window. The D field in the
DATA-FRAME Border is the calculated distance from the reticle
intersection to the reference mark.
The power on default for Reticle is off. When the reticle is first
turned on the reference mark will be at (X=0, Y=0) in the lower
left corner of the image area with the Reticle positioned at
X = 119, Y = 095 in the center of the image display area
on the monitor.
The origin of the coordinate set (X = 0, Y = 0) is the lower left
corner of the Imager display area. The upper right corner of the
Imager display area is X = 238 and Y = 191.
Press the RET POS softkey and
then use the arrow keys to move
the Reticle Position.
PLAY
5.23
Advertisement
Table of Contents
