Additional Resources - IBM N3400 Installation And Setup Instructions

b. Enter 5 to select the Onboard FC-AL test menu.
c. Enter 72 at the prompt to show attached FC-AL devices.
d. Exit the Diagnostic Monitor by entering 99 at the prompt. Enter the exit command to return to
LOADER. Start Data ONTAP by entering autoboot at the prompt
10. If your system does not boot successfully, it might not have the boot image downloaded on the boot
device. Call IBM Service and Support at 1-800-IBM-SERV (1-800-426-7378).

Additional resources

The following sources provide additional information about the N3400.
For more information about...
New features, enhancements, known issues,
and late-breaking news for your version of
Data ONTAP software
Setting up and verifying software
configuration
Configuring and managing the iSCSI or FC
protocol, and creating and managing LUNs
and initiator groups with the iSCSI or FC
service
Cabling, configuring, and disk ownership
Testing field-replaceable units and diagnosing
and correcting system hardware problems
Hardware configuration options for your
system
Troubleshooting the system
Configuring your remote management port
after initial setup
Safety information
The IBM System Storage N series support website contains additional information about N series
hardware and software products:
www.ibm.com/storage/support/nseries
22
Refer to the following IBM System Storage N series document
The Release Notes for your version of Data ONTAP
Data ONTAP Software Setup Guide
Data ONTAP Block Access Management Guide for iSCSI and FCP
Data ONTAP Active/Active Configuration Guide
Data ONTAP High Availability Configuration Guide
Data ONTAP System Administration Guide
Data ONTAP Data Protection Guides
Diagnostics Guide
Introduction and Planning Guide
N3300, N3400, and N3600 Hardware and Service Guide
Platform Monitoring Guide
Data ONTAP System Administration Guide
Safety Notices