IBM N3400 Installation And Setup Instructions page 25

Note: Clustering must be licensed on both nodes in a dual-node N3400.
7. Continue with post-setup configuration as needed.
8. Reboot the node(s) by entering the following command:
reboot
Initial setup is now complete for a single-node N3400.
Refer to the Data ONTAP Software Setup Guide for your version of Data ONTAP to verify that the
system is set up correctly and ready to operate.
To complete the initial setup of a dual-node N3400, continue to the next step.
9. Enable clustering by entering the following command on one node's console:
cf enable
10. Check each node's status by entering the following command:
cf status
Initial setup is now complete for a dual-node N3400.
Refer to the Data ONTAP High Availability Configuration Guide or the Data ONTAP Active/Active
Configuration Guide for your version of Data ONTAP to verify that the system is set up correctly and
ready to operate.
Installation and setup instructions
19