Connecting The N3400 To A Network - IBM N3400 Installation And Setup Instructions

Connecting the N3400 to a network

Use these instructions to connect the N3400 to a network.
Note: Use the cable management arms and hook-and-loop fasteners to organize your cabling.
Remote
Fibre
Management
Channel
port
1. Connect the RJ-45 to DB-9 adapter from the adapter kit to the Console port on the system.
0a 0b
SAS
S
A
S
2. Connect one end of the serial null modem cable to your console, then connect the other end to the
DB-9 end of the adapter.
0a 0b
SAS
S
A
S
3. Connect your system to the network by plugging the network cables into the networking ports,
labeled e0a and e0d.
0a 0b
SAS
S
A
S
4. If applicable, use an Ethernet cable to connect the Remote Management port to the network.
8
Ethernet
Console
e0P e0a
e0b e0c
e0P e0a e0b e0c
e0a
e0P e0b e0c
S
A
S
SAS
e0d
e0d
e0d