ORQA ORIGINAL BATTERY
The goggles should be powered by a power source with a voltage between 6.0
and 10.0 VDC. The best way to power your goggles is to use the supplied Orqa
Original Battery.
The Orqa Original Battery holds two 18500 Li-ion cells inside connected in 2S
configuration. The battery case features the battery fuel gauge. To check the
actual battery charge level, press and hold the button on top of the battery. The
battery fuel gauge displays the level with four LED-backlit bars. Each bar
represents roughly 25% of the full charge. The battery capacity is 2000 mAH.
The battery fuel gauge goes off after 2 seconds even if you are still holding the
button pressed. This will prevent the unintended battery discharge if the button
gets unintentionally pressed in transport.
Once the battery is empty, it needs to be recharged. To recharge the battery,
connect the barrel plug to the Li-ion battery charger.
The battery case features the standard JST 3 pole balance connector. The best
practice is to balance charge the battery in order to keep the cell's voltage on the
same level. This will ensure the optimal performance and long life of the battery
cells.
WARNING, FIRE HAZARD!
When transporting the battery ALWAYS plug the balance cable in the balance
connector on the battery case. This will prevent the accidental short circuit of the pins
in the balance connector. Shorting the balance pins will most probably destroy the
battery and could produce FIRE! Always carefully pack your batteries.
21
Orqa FPV.ONE User Manual, Rev.1.2
©2019. Orqa Ltd.