Menu Tree - GE SMOR-B GEK 105593C Instructions Manual

UP / DOWN ARROW: Change options. The equivalent of a horizontal movement within a menu. When the
required option appears on the screen it can be selected with the ENT key.
LEFT / RIGHT ARROWS: Show the different possibilities of a given setting. It is not used for all settings.
When the required option appears on the screen it can be selected with the ENT key.

8.1. MENU TREE.

The SMOR has different menus, divided into levels. Level 0 is the initial screen. Level 1 of the menus is
accessed by pressing the corresponding group key (SET, INF, etc). Moving within a given level is done by
using the UP and DOWN arrows. It is possible to go down to levels 2 and 3 by pressing the ENT key. Press
CLR to go up a level within the menu tree. Level 1 for each of the five groups is shown in the following table:
Group
• VIEW SETTINGS
SET
• MODIFY SETTINGS
• MODIFY COUNTERS
• STATUS
INF
• SET DATE/TIME
ACT
• BLOCK RECLOSER
• UNBLOCK RECLOSER
• COMM. TRIGGER
• RESET I MAXIMETER
• RESET POT MAXIMETER
• OPEN BREAKER
• CLOSE BREAKER
• I2
ENT
• Ia
• In
• Vab
• P
• COS PHI
• FREQUENCY
• TRIPS IN 1 HOUR
• I. MAXIMETER
• I2t A COUNTER
• I2t B COUNTER
• I
2
• Nº OPENINGS
• Nº RECLOSURES
• POT. MAXIMETER
Level 1
t C COUNTER
GEK-105593C
• View settings
• Change settings
• Change counters
• Show the status of the relay
• Change date and time on the relay
• Block the recloser
• Unblock the recloser
• Trigger oscillography by communication
• Reset current (I) maximeter
• Reset power maximeter
• Open the breaker
• Close the breaker
• Show negative sequence current in Amps
referred to primary
• Show phase A current in Amps referred to
the primary.
• Show ground current in Amps referred to the
primary
• Show voltage between phases AB in kV
referred to the primary
• Show Active Power in MW
• Show Power factor
• Show frequency in Hz
• Show the number of trips in the last hour
• Show current (I) maximeter
• Show the accumulated Amps counter for
phase A
• Show the accumulated Amps counter for
phase B
• Show the accumulated Amps counter for
phase C
• Show the number of opening operations
carried out
• Show the number of reclosing cycles carried
out
• Show power demand meter
70
Description