Table of Contents
Advertisement
The common settings are:
- GENERAL SETTINGS
- BREAKER SETTINGS
- ACTIVE TABLE SET
- OSCILLOS MASK
- FUNCTION PERMIT
The rest of the settings groups apply to each table independently. There are groups for each table, for
example, RECLOSER T1, T2, T3, which are recloser settings for each of the possible tables.
The steps to be taken in order to change any setting are as follows:
1. Press the SET key.
2. Select the option MODIFY SETTINGS.
3. Select the required setting in the menu trees.
4. ENTER the value to be modified ( or select the required value from the list of available settings using
LEFT/RIGHT ARROW keys).
5. Press the ENT key. To repeat the setting for a setting in the same group repeat steps 3 to 5.
6. Press the END key.
7. The relay will request confirmation of the change by means of the following message:
8. If you want to confirm this change press the 1/Y key. (If not, press 3/N).
9. The relay will then show the following message on the screen:
10. Press the CLR key repeatedly in order to return to the initial screen.
If the setting entered is outside the limits of the range allowed for that setting, the relay will not accept the
change and will show the following message:
Some settings do not require you to key in a numeric value, but to choose an option from a series of
possibilities. In this case the options can be viewed using the LEFT/RIGHT ARROW keys.
Example : Configure the DEMAND TIME as 15 minutes.
GEK-105593C
CONFIRM?
Y/N
SETTINGS CHANGE
EXECUTED
SETTING
OUT OF RANGE
77
Advertisement
Table of Contents
