Configuring Windows 95 For Ip Networking - NETGEAR RT328 Getting Started

Before using FirstGear, you must first verify that a network adapter card is installed in your PC
and that the TCP/IP component is installed and associated with your network adapter.
If you are using a PC with Windows 3.1, you must have a TCP/IP application package such as
NetManage Chameleon. If you are using Windows 95 or Windows NT, you can configure through
the application.
The instructions in this appendix provide the minimal basic setup that is most commonly used.
Your network administrator might instruct you to enter either less or more information.
Configuring Windows 95 for IP Networking
To configure Windows 95 for IP networking, follow these steps:
Select Start from the Windows tool bar (located at the bottom of the screen).
1.
Select Settings.
2.
Select Control Panel.
3.
Select Network.
4.
Look at the list of installed components. You will need Client for Microsoft Networks, the
TCP/IP protocol, and/or your Ethernet adapter.
If you need Client for Microsoft Networks, follow these steps:
Press the Add button.
a.
Select Client and press the Add button.
b.
Select Microsoft.
c.
Select Client for Microsoft Networks and press the OK button.
d.
Configuring TCP/IP
Appendix A
Configuring TCP/IP
A-1