Table of Contents
Advertisement
www.ti.com
•
In the Debug Menu, right click on the TI MSP430 USB1_0 connection and select Connect Target
(see
Figure
•
After the device connects, go to Run -> Load -> Load Program (see
BOOST-DRV8848 Hardware and Software Files folder that was downloaded from the tool folder.
Go into the Application subdirectory and then go into the GUI subdirectory. Select the
appProgram.out file (Application\BOOST-DRV8848_GUIvX.X\appProgram.out).
•
After a short delay, the appProgram.out file is loaded onto the MSP430G2553 (see
error message may display saying that the source was not found. Receiving this message is OK,
as long as the binary was loaded.
•
Close CCS
SLVUAE1 – December 2014
Submit Documentation Feedback
9)
Figure 9. Connect Target Selection
Figure 10. Load Program Selection
Figure 11. Load Program Complete
Copyright © 2014, Texas Instruments Incorporated
Brushed Motor Demo Application
Figure
10). Browse to the
Figure
11). An
BOOST-DRV8848
9
Advertisement
Table of Contents
