Operation And Programming - Xceltronix autoCLOSER Series Installation Manual And User's Manual

OPERATION AND PROGRAMMING
The Autocloser s^'stcm is ready to operate straight out of the box. Once installed, the unit
will aulotnaticallyclose your garage door aHer the preset software timer has finished it's
count. The system features are enumerated below.
1) Temporary Disable • This disable is intended to temporarily disable the system so
that the garage door will not automatically close. This feature can only be utilized
when the garage door is fully open. To activate 'temporary disable',press the disable
button when the garage door is open—NOTE: Thedoormustbe completely openin
orderfor the disable button to be recognized. The .Xutocloser willbeep twice indicat
ing that the unit is in 'temporary disable'. The red disable light will begin to blink.
To deactKate 'temporary disable*, close the garage door. Pressing the disable button
a second time while the garage door is open will not deactKate 'temporary disable*.
If the disablebutton is pressed while the unit is in ' temporarydisable', the Autoclos
er willsigiul the error with two beeps whilethe button is depressed, followed by six
beeps when the button is released. The Autocloser will remember that it b in this
mode if the power b intorupted.
TIP-Ifthegarage door ispartially closed, theAutocloser wilt think the door isfully
closed and will never perform the auio closing function. Because the unit thinks the
door is closed, it cannot beput into 'temporarydisable
2) Malfunction Dbable - Thb dbable occurs automatically whenthe garage door fails
to close after two Autocloser attempts. When the unit b in 'mal^nction dbable'
mode, the red dbable light will blink and the unit will beep once every 20 seconds.
Determine if something b blocking your garage door then re-enable the unit by
pressing the dbable button. The unit will beep 3 times.
3) Auto close Cancel - The current auto closing operation can be cancelled when the
unit b sounding the audible closing alarm (auto close state). The operation can be
cancelled by pressing the dbable button which will reset the software timer. The unit
will immedblely begin the software timer counting again.
The auto closecancel feature WILL NOT reverse a door that is already moving.
Thb feature simply cancels further Autodoser operation. If the door is already
closing and it needs to be stopped, the garage door opener button should be
pushed!