Xceltronix autoCLOSER Series Installation Manual And User's Manual page 16

STAY AWAY FROM THE DOOR WHILE IT IS CLOSING - THE GAR
AGE DOOR CAN CAUSE SEVERE INJURYIM
the timer finishes it's counL the system will perform the door closing
procedure. When the door hits the obstruction, it should return to the open
position. The .Autocloscr will attempt to closethe door twice. \Mienthe Auto-
closer has finished its closing cycle, it will sense that the door has not closed
and transition to 'malfunction disable' mode. Note: the red disable LED will
begin to blinkand the unit willbeeponceevery20 seconds. Pressthe disable
button to exit maliunction disable. The Autocloser will beep three times to
indicate that it is leaving the malfunction disable mode and returning to nor
mal operational mode.
TIP: To minimize the time required to test, set the Autocloser delay time to
two minutes, (see Operation and Programming Item (4).)
E. Open the door. Simulate an obstruction in the doorway by placing a piece of
masking tape (non-clear) over one of the photo eye lenses.
STAY AWAY FROM THE DOOR WHILE IT IS CLOSING - THE GAR
AGE DOOR CAN CAUSE SEVERE INJURYIM
When the timer finishes its counL the system will perform the door closing
procedure. The photo eyesystem should allow the doorto move onlyslightly.
When the Autocloser has fmished it's closing cycle, it will sense that the door
has not closed and transition to malfunction disable mode. Note: the red disa
ble LED will begin to blink and the unit will be^ once e\'ery 20 seconds. Re
move the tape &om the photo eye.Press the disablebutton to exit malfunction
disable mode. The Autocloser will beep three times to mdicate that it is leav
ingthe malfunction disable mode and returningto normaloperationalmode
F. Test for false reflections. Shut the garage door and switch the unit to 'Set Up'
mode. Verify that the beeper does not make any noise. If the beeper is
sounding, make sure there is nothing in front of the Autocloser unit causing
fabe reflections.
G. Instalbtion of your Autocloserunit b complete. If you purchasedan optional
I-Opener, proceed to the I-Opener installation instructions. If you did not
purchase an I-Opener, proceed to the Operation and Programming instruc
tions. If you did not purchase an I-Opcner, one can be purchased and added
at any time by vuiting our website: www.autocloser.com, or by calling 972-
437-9393.