Xceltronix autoCLOSER Series Installation Manual And User's Manual page 2

Autocbser is designed and manufactured by
, XCEllROINix
idt.>s .t-id ln.^^oltx,v ujMt
Made in
the
U.S.A.
MEN'BER
IDA
InkMnallunal fXmr AsM>ciutii)n
r.'.vr..'; 1.,^.:.. . • I/..,'. >•
NOTE: This equipmenthas been tested and foundto complywith the limitsfor a Class
B digitalde\'icc, pursuantto part 15of the FCC Rules. These limitsarc designedto pro
vide reasonable protectionagainst harmful interference in a residentbl installation. This
equipment generates, uses andcanradiate radio frequency energy and, if not installed
and used in accordancewdh the instructions, may cause harmfulinterference to radio
communications. However, there is no guaranteethat interference will not occur in a
partkubr installation. If thisequipment doescauseharmful interference to radio or tel
evision reception,which can be determinedby turning the equipmentofTandon, the
user is encouraged to try to correct the interference by one or moreof the following
measures:
- Reorient or relocate the receiving antenna.
Increase the separationbetweenthe equipmentand receiver.
Connect the equ^ment into an outlet on a circuit differentfrom that to whichthe
receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
CALTION: Any modifications made to the Autocbser withoute.xpress approvalby
Xcehronix, Inc. could void the user's authority to operate said equipntent.