Travel To Reference Points; Clamping And Releasing The Tool - KELCH KENOVA set line V9 Series Operating Instructions Manual

- Motor-driven axis travel
o Both the linear axes and the C-axis can be driven by operating the trav-
el axes
o Pressing the "Fast" button together with the appropriate axis button
causes the movement to be made rapidly
- Manual fine adjustment
o All motor-driven axes can be moved by operating the electronic hand
wheels. This is particularly useful in fine adjustment as the linear axes
move in the µm range.

4.3.3 Travel to reference points

The reference points of the axes are driven over after each restart of the setter appli-
ance. This is done as follows:

4.3.4 Clamping and releasing the tool

The KENOVA set line V9xx(-S) setter is fitted with a modular precision spindle. It is fit-
ted with the insertion module for a particular tool size. The insertion modules can be
exchanged; to do this, proceed as follows:
- Clean the adapter spindle, insertion module and tool
- Insert the tool, making sure of the correct groove position
- Press the "Clamp tool" button
- To release the tool, the operation can be assisted by the use of compressed
air ("Release tool" button)
Page 24
Kelch GmbH · Werkstraße 30 · D-71384 Weinstadt-Endersbach · Tel. (+49)7151 20522 0 · Fax (+49)7151 20522 11 · info@kelchgmbh.de
- Put the main switch of the tool presetter to On
- Drive all three axes over the reference marks: Move the axes by
50 mm in each direction, up/down and left/right, and a half-turn
for the rotation axis. This can be done manually or motor-driven.
- If the device – on switching off – is automatically driven to the
park position, the reference points can also be automatically
driven over. The appropriate prompt for this is to be confirmed
with OK.
KENOVA set line V9xx(-S)
4. Operating
© Kelch GmbH 2014