Connecting Cables For The Peripheral Devices; Procedure When Cabling Up; Acceptance Test - KELCH KENOVA set line V9 Series Operating Instructions Manual

3. Commissioning

3.6.1 Connecting cables for the peripheral devices

The PC is already cabled up on delivery, the connecting cables for the peripheral
devices are led out and labelled

3.6.2 Procedure when cabling up

 Make sure that the main switch is off.
 Position peripheral devices on the peripherals carrier (see cover page for
example).
 Connect up the power cable to the peripheral devices to the mains. Follow
the documentation on this that is supplied with the peripheral devices.
Later, the peripheral devices are switched on together via the main switch.
 Connect the data cables, according to the labelling, with the peripheral de-
vices.
 Connect the printer cable to the printer.
 Plug the low-voltage cable of the printer mains adapter into the printer.
 Put the power switch of the printer to "I" (On).
 Proceed in the same way with any other printers in the scope of supply.
 Connect the mouse and keyboard to the hub.
 Connect the power cable of the KENOVA set line V9xx(-S) to the mains.

3.7 Acceptance test

After the commissioning, the KENOVA set line V9xx(-S) must be checked by spe-
cialists from Kelch GmbH that the geometry has been adhered to. Adhesive
maintenance labels and data protocol are then handed over.
Note!
KENOVA set line V9xx(-S)
Kelch GmbH · Werkstraße 30 · D-71384 Weinstadt-Endersbach · Tel. (+49)7151 20522 0 · Fax (+49)7151 20522 11 · info@kelchgmbh.de
Without a valid data protocol, Kelch GmbH assumes no respon-
sibility for the specified measuring precision of the appliance!
© Kelch GmbH 2014
Page 21