Save the carton and all packing materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing. Your shipment includes: ● Showtec TR-512 Wallpanel (RJ45) ● User manual Safety Instructions Every person involved with the installation, operation and maintenance of this device has to: ●...
Never attempt to bypass the thermostatic switch or fuses. ● The user is responsible for correct positioning and operating of the TR-512 Wallpanel (RJ45). The manufacturer will not accept liability for damages caused by the misuse or incorrect installation of this device.
TR-512 Wallpanel (RJ45) Return Procedure Returned merchandise must be sent prepaid and in the original packing, call tags will not be issued. Package must be clearly labeled with a Return Authorization Number (RMA number). Products returned without an RMA number will be refused. Highlite will not accept the returned goods or any responsibility.
Features The TR-512 Wallpanel (RJ45) is a compact wall panel equipped with 6 trigger buttons. Each trigger can start either a show or a scene. Each show can be played in a loop mode or single play mode. It is also possible to set a delay, which enhances your control of the shows.
TR-512 Wallpanel (RJ45) Installation Remove all packing materials from the TR-512 Wallpanel (RJ45). Check that all foam and plastic padding is removed. Connect all cables. Do not supply power before the whole system is set up and connected properly. Always disconnect from electric mains power supply before cleaning or servicing.
● Without the jumper: The TR-512 trigger (50825) should be set to NO_TR. Press one of the 6 trigger buttons on the Wallpanel to run a program. If you press the button again, the device will wait until the currently active program reaches its end and then it will stop. Refer to the user manual of the TR-512 (50825) for more information.
05) If all appears to be O.K., plug the unit in again. 06) If you are unable to determine the cause of the problem, do not open the TR-512 or the Wallpanel, as this may damage the unit(s) and the warranty will become void.
Page 10
TR-512 Wallpanel (RJ45) Problem Probable cause(s) Remedy The device does ● Check if power is switched on and No power to the device not function at all cables are plugged in Fixtures reset The controller is not connected ● Connect controller...
TR-512 Wallpanel (RJ45) Product Specifications Model: Showtec TR-512 Wallpanel (RJ45) Dimensions: 85 x 85 x 36 mm (LxWxH) Weight: 0,1 kg Operation and Programming Signal output: RJ45 OUT Electro-mechanical effects Trigger buttons: Installation depth: 29 mm Connections: Trigger connector RJ45...