Table of Contents
Advertisement
S a f e t y r e g u l a t i o n s
Verletzungen verursachen. Bei Verletzungen du-
rch Hydrauliköl sofort einen Arzt aufsuchen, da
sonst schwere Infektionen entstehen können.
When performing adjustment work in the hydraulic
system do not step or stand in front of or behind
the drum.
Do not change the setting of high pressure relief
valves.
Drain hydraulic oil at operating temperature - dan-
ger of scalding!
Catch running out hydraulic oil and dispose of sep-
arately.
Always catch and dispose of biological hydraulic
oils separately.
Do not start the engine after draining off the hy-
draulic oil.
Nach allen Arbeiten (bei noch druckloser Anlage!)
die Dichtheit aller Anschlüsse und Verschraubun-
gen prüfen.
Wear your protective outfit!
Changing hydraulic hoses
All hydraulic hoses must be inspected visually at
regular intervals.
Hydraulic hoses must be immediately replaced in
case of:
the outer layer is worn down to the metal lining
l
(e.g. chafing, cuts, cracks)
embrittlement of the outer layer (development
l
of cracks in the hose material)
deformation under pressurized and deoressu-
l
rized condition, which are not in accordance
with the normal shape of the hydraulic hose
deformation in bends, e.g, squeezes, kinks,
l
layer separation, formation of blisters
leakages.
l
incorrect installation.
l
separation of the hydraulic hose from the fit-
l
ting
corrosion of the crimped fittings, which will im-
l
pair the function and reduce the strength.
Do not mix up hoses by mistake.
l
damage or deformation of the fitting, which im-
l
pairs the function and strength of the hose/
hose connection.
1 4
Only genuine BOMAG hydraulic hoses ensure
that the correct type of hose (pressure range) is
used at the right place.
Working on the engine
Drain the engine oil at operating temperature -
danger of scalding!
Wipe off spilled oil, catch running out oil and dis-
pose of environmentally.
Store used filters and other oil containing materials
in a specially marked container and dispose of en-
vironmentally.
Working on electric components
Before starting to work on electric components dis-
connect the battery and cover it with insulating ma-
terial.
Working on the battery
When working on the battery do not smoke, do not
use open fire.
Do not let skin and clothes come in contact with
acid.
In case of injuries caused by acid flush the respec-
tive parts with clear water and consult a doctor for
medical advice.
Do not place any tools on the battery, danger of
short circuit.
When recharging the battery remove all plugs to
avoid an accumulation of explosive gases.
Dispose of old batteries environmentally.
Working on the fuel system
No open fire, do not smoke, do not spill any fuel.
Catch running out fuel, do not let it seep into the
ground and dispose of environmentally.
Cleaning
Do not clean the machine while the engine is run-
ning.
Do not use gasoline or other combustible sub-
stances for cleaning purposes.
When using steam cleaning equipment do not
subject electric parts to the direct water jet or cover
it beforehand.
Do not guide the water jet directly into the air filter
and into the air intake opening.
B O M A G
BPH 80/65
Hide quick links:
Advertisement
Table of Contents
