Installation; Use; Maintenance And Repairing Failures - BRAVILOR BONAMAT RLX Series Operating Instructions Manual

Installation

D The maximum acceptable ambient temperature with which a good operation can be guaranteed is 40°C.
D Never install the machine in an environment where the temperature can drop below 0°C.
D Do not turn over the machine, move it upright.
D Never install the machine in places where water is sprayed or sprinkled.
D Never install the machine in front of entrances, exits or passageways intended for emergency
services.
D Place the machine on a sufficiently solid, flat surface close to a water connection, water discharge
and an earthed electrical power outlet.
D Connect the machine to the electrical supply in such a way that the power can easily be
disconnected.
D Machines hard wired into mains electricity supply we advise to use an Earth Leakage Circuit
Breaker (ELCB) of the appropriate rating (max. 30 mA).
D Leave sufficient space at the back and front of the machine for maintenance and repair purposes.
D The machine should be connected to the electricity mains in such a way that all phases and the zero
can easily be disconnected. The minimum distance between the contacts and the disconnected
position should be at least 3 mm.
D Connect the machine to a readily accessible, manually operated water tap, so that the water supply
can easily be turned off.
D Always observe local rules and standards when installing this machine.

Use

D Inspect the machine before use and check for damages.
D Protect the machine against water and moisture. Do not wet the machine by spraying and never
submerge the machine in water.
D Keep the operating controls free from dirt and grease.
D Note that during use some parts of the machine become very hot.
D Disconnect the electricity grid and the water supply when the machine will not be used for a longer
period. Clean the machine following the instructions. Discharge the water.
D Should the internal water ways of the machine become frozen, disconnect from the mains, turn off
the water supply and disconnect and place the machine in a warm environment until the water ways
have defrosted. Inspect and test machine for water leakage.

Maintenance and repairing failures

D Repair and maintenance activities not included in this document must always be carried out by
service mechanics.
D If the mains lead is visibly damaged, it has to be replaced by a qualified service technician.
D Observe the given maintenance intervals. Overdue maintenance can lead to high repair costs and
may cause guarantee claims to become invalid.
D Do not carry out any maintenance activities concerning the machine before having it protected
against unintentional coming into operation. In such cases disconnect the electricity grid.
D Never leave the machine during maintenance activities.
D For cleaning the machine only use the cleansing agent and descaler recommended by the
manufacturer.
D Always wear suitable facial protection and gloves while working with cleansing and descaling
materials. Wash your hands after using these materials.
D Prevent damage of the machine caused by spilled descaler solution. Remove spilled solution as
quickly as possible and follow the previously mentioned safety instructions.
ECopyright Bravilor Bonamat B.V. V