Installation And Operation; Adjust The Quantity Of Water - BRAVILOR BONAMAT Matic Operating Instructions Manual

1.5 Installation and operation

1. Place the machine on the work
surface.
2. Check whether the machine is
positioned steady and horizontally.
3. Make sure there is an earthed mains
connection and water supply in the
close vicinity.
4. Connect the machine to the water
supply (with a tap) using the
connecting hose supplied.
5. Slide an empty filter pan (6) into
position and place an empty decanter
(5) beneath it. CAUTION! The lid of
the vacuum flask or airpot must be
opened for the THA model. Keep the
mixing tube in the flask when using
an airpot.
6. Set all the switches (1, 2 and 3, if
present) to "off".
7. Put the plug in the wall socket.
(earthed).
8. Turn the machine on by setting the
switch (1) to "on". The switch lamp will
come on. The lamps (10.1, 10.2) and
the display will light up briefly. The
display will then indicate the standard
number of cups.

1.6 Adjust the quantity of water

You can adjust the quantity of hot water
used to brew the coffee. This is set to a
standard amount when the machine
leaves the factory. If you think this setting
is supplying too much or too little water,
you can change the amount as follows:
1. Press the - and the
same time and keep them pressed in
until P1 appears in the display (after
about 15 seconds).
2. Release the keys. The display will
now show the setting for the current
quantity of water . This quantity varies
from machine to machine.
1
/ -keys at the
0
1
9. Press the / -key. You will hear an
0
acoustic signal.
10. Wait for about 3 minutes. If the water
has still not started flowing, press the
1
/ -key again.
0
11. The decanter will now start to fill.
12. Once the water has stopped flowing,
you will hear a three-note acoustic
signal after 1 minute. Now you can
empty the decanter.
The machine is now ready for use.
Remarks:
1. Some water will always remain in the
machine, its hoses, boiler, etc. This
must be taken into account when:
−
moving the machine
−
the machine is situated in a room
where the temperature falls below
freezing point.
2. If, for any reason, no water is left in
the machine, you must repeat the
above procedure (from step 5 to 12).
WARNING
Ensure the flex does not touch the
heating plate.
3. Press the -key for more water or the
1
/ -key for less.
0
4. The settings available range from 0,
2, 4, 6... to 98. Two steps higher will
give you 3,3 to 5 ml extra water in the
decanter. Wait for about 20 seconds.
The machine is now ready for use.
For other settings of the hot water
quantity, see the table on the fold out
sheet at the back of this manual.
5