Humidification Cleaning Function; Humidification Cleaning Operation - LG AM30GUWF1 Owner's Manual

Humidification cleaning function

Humidification cleaning operation

1. Press the button.
2. Set to the humidification cleaning mode with
• You cannot set to the desired humidity.
• During the humidification cleaning operation, the humidification is done with fine particle, so
you will not see the spraying.
3. Select the desired wind amount with Speed button.
• Whenever you press the Speed button, it is changed in the order of Auto → Low → Mid →
High → Auto.
!
NOTE
• When there is no water in the water tank, the no-water lamp is turned on and buzzer
sounds, but the operation does not stop. During the humidification operation, when you
separate the water tank and tray from the product, no-water is turned on and buzzer
sounds also, but the operation does not stop. During the operation, do not separate the
water tank or the tray.
• During the operation, if no-water lamp is turned on, make sure to turn off the power,
separate the water tank, supply water into the water tank, combine with the main unit, and
operate.
• There are cases not becoming adequate humidity or rising too high according to the area
or state of the installed room
It does not become adequate humidity. --- Operate with higher wind amount.
It is over adequate humidity. --- Turn off the humidification cleaning operation.
4. After the humidification cleaning operation, when
you turn off the power, press
button to change to the cleaning operation and
operate for about 5 minutes.
• The wet humidification filter is dried quickly and
maintained cleanly.
Humidification cleaning function
Mode button.
operation mode
19
Humidification
filter