MAINTENANCE
Cleaning
Cleaning the Exterior
Remove any dust from the air inlet and outlet
1
using a vacuum cleaner.
Wipe the exterior with a soft cloth.
2
WARNING
• Turn off and unplug the appliance before cleaning or
replacing the filter.
• Do not spray water directly onto the product.
CAUTION
• Do not clean the appliance with an alkaline
detergent.
• Do not wipe the appliance surface using sulfuric
acid, hydrochloric acid or organic solvents
(thinner, kerosene etc.) or attach a sticker on
the appliance. This may damage the appliance
surface.
• Do not allow water inside the appliance.
NOTE
• If you find it difficult to remove dust from the front
and rear covers, remove the filters and wash
them with water. Then, dry them completely in
the shade.
Cleaning the PM1.0 Sensor
The PM1.0 (particles with a diameter between 1.0
and 2.5 micrometers) sensor is the device detecting
fine dust and large dust contamination levels, so
the lens must be cleaned periodically, at least once
every 2 months.
Separate the front cover with the LG logo
1
from the product.
Open the sensor cover.
2
Clean the lens with the cotton swab soaked
3
with water and clean it again with a dry cotton
swab.
NOTE
• Do not wipe the sensor with anything other than
water. This may cause failure.
MAINTENANCE
21
EN