Outrigger Operation; Setting Outriggers From The Platform/Remote; Console - JLG X430AJ Operation And Safety Manual

SECTION 4 - MACHINE OPERATION
4.6

OUTRIGGER OPERATION

BE CERTAIN OUTRIGGER PADS ARE SET ON A FIRM AND HORIZONTAL SUR-
FACE. DO NOT SET OUTRIGGER PADS ON INCLINED, VERTICAL, OR SLIPPERY
SURFACES.
THE OUTRIGGERS WILL NOT OPERATE UNLESS THE BOOM AND JIB ARE COM-
PLETELY LOWERED, RETRACTED AND ALIGNED WITH THE BASE.
NOTE: Base and boom/jib must be aligned and stowed
before this function will operate, see Section 4.4, BASE
AND BOOM/JIB ALIGNMENT.
Setting Outriggers From the Platform/Remote Console
(Reference Figure 4-3. on page 4-16 for item number location)
Either - Press and hold the outrigger auto-
set and level button 7 (item 7) until OK
appears on the platform LCD display;
AUTO
or
7
3121773
Operate each outrigger separately by
pressing button 2 (item 2) to select which
MANUAL
outrigger to control (each outrigger is num-
bered 1 thru 4, see decal, each press of but-
ton 2 displays the outrigger selected on the
SELECT
LCD display). Press button 1 (item 1) to
retract or button 7 (item 7) to set that out-
2
rigger. The OK will appear on the display
when the outriggers are set properly and
the unit is level.
Note: To cycle back to outrigger auto-set
mode, press button 2 (item 2) until the
LCD display shows the normal operating
icons.
– JLG Lift – 4-11