Digital Networks DECserver 90M+ Installation Manual page 36

On-Board Flash Memory
Procedure to determine the DECserver 90M+ Firmware Version:
Step
1
2
3
2-16 Installation
Action
Attach a terminal to the console port. (Factory Defaults: Port 1,
Baud=9600, Parity=None, Databits=8, and StopBits=1) If your
configuration settings have changed you console settings may
be different.
If your DECserver is already booted and running DECserver
Network Access Software skip to section B:
A) Apply power. When self-test completes the following will be
displayed on the console:
Local>
Local -901- Initializing DECserver 90M+
00-10-64-8E-A2-3B FW V 1.5 HW 1.0
. . .
Proceed to Step 3.
B.) From the DECserver Network Access Server "Local>"
prompt type the following:
Local> show server
Network Access SW V2.6 BL53 for DS90M+
ROM 1.5 Uptime: 0 00:02:42
...
In both of the previous examples the firmware version was
shown to be V1.5.