Napoleon BIPRO 825-3 User Manual page 19

Problem
Ignitor, oven and
cabinet lights work but
the knob lights don't
illuminate when turning
the power switch ON
Illumination of the knob
and switch lights work fine,
but the side/rear burner
ignition does not work
Illumination but can't
ignite the side or rear
burner, even when
sparking noise occurs
N415-0543CE-GB-DE JuNE 04.19
N415-0543CE-GB-DE.indd 19
Possible Causes
The motion sensor detector
does not work properly
The wire harness does not work properly
The ignitor switch does not work properly
The ignitor block does not work properly
The gap between electrodes
is too big or too small
Solution
Ensure the blue indicator is ON
Turn the sensor ON by clicking
the motion detector button
If blue indicator is ON, replace
the motion sensor
Replace the wire harness of the control panel
Replace the ignitor switch if the switch light
illuminates when you turn the light switch on
Check the switch connection inside
the control panel If there's no light on
the switch when you turn it on.
Replace the ignitor block if the switch
illuminates and sparking noise can be heard.
Adjust the gap between two prongs
of the side burner electrode when
the side burner does not ignite.
Adjust the gap between the electrode
and the rear burner when the rear burner
when the rear burner foes not ignite
19
EN
www.napoleon.com
6/4/2019 2:11:43 PM