Menu System - Nibe F1155 Installer Manual

Menu system

When the door to the heat pump is opened, the menu
system's four main menus are shown in the display as
well as certain basic information.
Outdoor
temperature
INDOOR CLIMATE
SERVICE
HEAT PUMP
Temporary lux (if activated)
Menu 1 - INDOOR CLIMATE
Setting and scheduling the indoor climate. See inform-
ation in the help menu or user manual.
Menu 2 - HOT WATER
Setting and scheduling hot water production. See in-
formation in the help menu or user manual.
This menu only appears if a water heater is docked to
the heat pump.
Menu 3 - INFO
Display of temperature and other operating informa-
tion and access to the alarm log. See information in
the help menu or user manual.
Menu 4 - HEAT PUMP
Setting time, date, language, display, operating mode
etc. See information in the help menu or user manual.
Menu 5 - SERVICE
Advanced settings. These settings are only intended
for installers or service engineers. The menu is visible
when the Back button is pressed for 7 seconds, when
you are in the start menu. See page 43.
38 Chapter 7 | Control - Introduction
Indoor temperature - (if room sensors are installed)
HOT WATER Hot water temp.
Information about
operation
INFO
Estimated amount of hot water
Symbols in the display
The following symbols can appear in the display during
operation.
Symbol Description
This symbol appears by the information
sign if there is information in menu 3.1
that you should note.
These two symbols indicate whether the
compressor or addition is blocked in
F1155.
These can, for example, be blocked de-
pending on which operating mode is se-
lected in menu 4.2, if blocking is sched-
uled in menu 4.9.5 or if an alarm has oc-
curred that blocks one of them.
Blocking the compressor.
Blocking additional heat.
This symbol appears if periodic increase
or lux mode for the hot water is activated.
This symbol indicates whether "holiday
setting" is active in 4.7.
This symbol indicates whether F1155 has
contact with NIBE Uplink™.
This symbol indicates the actual speed of
the fan if the speed has changed from
the normal setting.
Accessory NIBE FLM required.
This symbol indicates whether solar
heating is active.
Accessory needed.
This symbol indicates whether pool
heating is active.
Accessory needed.
This symbol indicates whether cooling is
active.
Accessory needed.
NIBE™ F1155