infaco A3M V2.0 Instructions For Using Manual page 9

Insert the wire into hole 01
If you come up against an obstacle
during insertion, move the wire gent-
ly backwards and forwards and/or
press once or twice the control switch
to pivot the tying head and to keep
the wire moving through the machine
01
Unclip the brake system lever 01
At the start of each reel, check
that the wire is properly rolled and
doesn't stick between cheeks 02 and
03
01
02
03
Keep on feeding the wire through un-
til it emerges from the tying head 01.
IF THE WIRE STILL DOESN'T COME
OUT: we recommend that you dis-
connect the tying head (See chapter
"Operating problems" P16), check
that the wire isn't stuck and try to in-
sert it with the head removed
Switch the machine on and press
briefly on the control switch to cut
the excess wire.
You can now start tying operations
9
01