infaco A3M V2.0 Instructions For Using Manual page 10

REMOVING THE REEL
Clip lever 01 upwards to allow the
wire free movement through the
passage
Pull directly on the reel to unclip it from
the machine.
REEL WITH REMAINING WIRE
EMPTY REEL
Pull the reel to unclip it from the
machine
Carry out a visual check on wire exit
01 to ensure that there is no wire
remaining in the machine.
01
After the last tying operation it is
possible that some wire may remain
stuck in the tying head:
• If it does not prevent you from loa-
ding another reel, carry on working.
It will come out during tying, usually
without a problem.
• If it does prevent you from feeding
a new wire through, disconnect the
head and remove the remaining
wire by hand (See chapter "Solving
operating problems").
10