infaco A3M V2.0 Instructions For Using Manual page 22

THE TYING HEAD IS STUCK, THE MACHINE NO LONGER
Push rod 01, which hits against ring 02
when the wire is cut, sometimes goes
out of its trajectory and become stuck
on the outer edge of ring 02. The arm
03 often remains locked and can't open
completely
Do not try to force arm 03 open as you
may damage the mechanism.
Ring 02 is released when the push rod has returned to its initial position. The arm 03
must be fully open. Check that the tying head can turn freely again. You can then
switch the machine back on and resume tying operations.
OPERATES
01
03
Bring tying head 01 in to a central
working position, following the arrow
below. Then take hold of ring 02 and
move it forwards and backwards until
the push rod returns to its position be-
neath ring 02.
It is normal for the tying head 01 to
resist and make you force it to bring it
back into its operating position.
02
22