Operating Problems - infaco A3M V2.0 Instructions For Using Manual

OPERATING PROBLEMS

Unless stated to the contrary, these tasks should be carried out with
the machine disconnected.
THE LOOP NO LONGER FORMS AROUND THE BRANCH
DURING THE TYING OPERATION
A piece of wire may be stuck in the
To release it, press pin 02 in the circular
wire pincher 01.
orifice with your fingernail or using the
supplied pliers
01
02
The wire may be bent at exit 01: (no need to disconnect the machine) simply
go through the cycle empty or run the knife only and resume the tying action.
01
20