User Guide - infaco A3M V2.0 Instructions For Using Manual

USER GUIDE

MAKING A TIE (the machine should be switched on).
Hold the end of the branch and the
trellising wire firmly in your free
hand and bring the A3M V2 closer
Position the tying head just before
the last node on the branch.
Move the machine back firmly to release
the tying head: the wire then wraps
round the branch. Press control switch
01 to complete the tie.
01
The knot is made more or less tight
depending on how far you pull back
the machine: See next chapter.
TIGHTENING THE KNOT
See attached sheet:
"APPROPRIATE TYING METHODS P18"
Firmly place the branch + the trellising
wire inside the tying head
01
Go right up to the abutment to en-
sure that the arm closes fully and at-
taches the wire correctly.
The tie holds the branch on the trel-
lising wire.
11