STEINEL IR Quattro HD LiveLink Information page 8

Reach setting
(IR Quattro HD LiveLink)
Potentiometer d
Adjustment of the reach to See table on page 5.
individual requirements
Reach setting
(DUAL HF LiveLink)
DUAL HF LiveLink - mounting height 2.8 m
The DUAL HF LiveLink sensor
has 2 special HF sensors that
detect movement from the
ceiling in both corridor direc-
tions. An app can be used to
set the reach electronically in
either direction at the same
time.
- 14 -
Electrical installation / Automatic mode
The wiring leads selected for in- a multiple-core lead containing
stallation must comply with the both the mains voltage leads and
regulations laid down in VDE 0100 the control leads (e.g. NYM 5 x 1.5)
(see Safety Precautions on page may be used for the wiring be-
12). For the wiring of the presence tween sensor and LiveLink Box.
detector, the following applies: The lead between LiveLink Box
Under section 6 of VDE 0100 520, and sensor must be no longer
Using several sensors
Several sensors can be connect- DALI users must not be exceed-
ed in a LiveLink system. In this ed (see Technical Specifications
case, the maximum number of on page 17)
L N
LiveLink
S
BOX
L DA
Declaration of Conformity
N DA
This product complies with
- EMC Directive 2014/30/EU
- RoHS Directive 2011/65/EU
- WEEE Directive 2012/19/EU
DA
L DA
EVG
N
than 300 m (for 1.5 mm
installing and switching on the
LiveLink Box, the sensor starts
to flash once a second during
the initialisation cycle.
IR Quattro HD LiveLink 40 s;
DUAL HF LiveLink 10 s.
DALI
DALI
DA
DA
DA
Sensor
DALI
- 15 -
). After
2