Gas Tap Maintenance - Baumatic Pythagora P62SS Instruction Manual

G as tap maintenance
These mainte
o ut by a CORGI registered engineer.
IMPORT ANT: Before carrying out any mainten
disconne t the appliance from the gas and electricity supplies. c
If a gas tap becomes stiff to operate, then you should proceed as
follows:
o Remove the control knobs, pan supports, burners, hob fix
screws and clamps.
Remove the hob from
o
protective covers.
Disconnect the fixin
o
separate the assembly. Then clean the cone and seating, with
a cloth dampened with solvent.
Lightly smear the cone with high
o
reassemble into position and rotate a few times.
Remove the cone again and remove any excess g
o
making sure that the gas ducts are not obstructed with
grease.
Carefully
o
soundness test.
If it becomes necessary to replace a gas tap, then you should proceed
a s follows:
o Rem ove the control knobs, pan supports, burners, hob fixing
screws and clamps.
Remove the hob from
o
protective covers.
Disconnect the fixin
o
separate the assembly.
Disconnect the gas pipe
o
them from the gas rail by removing the fixing screws.
When fitting a new tap, ensure that a new gasket is us
o
o Reconnect the gas tap, perform a gas soundness test and
then reassemble the hob.
nance operations MUST ONLY be carried
the worktop and remove any underside
gs holding the tap to the fascia panel and
reassemble the components and perform a gas
the worktop and remove any underside
gs holding the tap to the fascia panel and
from the gas tap, then disassemble
ance operations,
temperature grease,
rease,
ing
ed.
22