Disassembling And Assembling Handle And Control Parts - Yamabiko ECHO PB-2520 Service Manual

PB-2520
EB252

5-1 Disassembling and assembling handle and control parts

B
E
D
A
E
J
H
D
C
B
HANDLE AND CONTROL SYSTEM
C
A
A
F
G
A
a1
a2
1. Remove engine cover from inner fan case (A)
(Refer to "4-6 Replacing ignition module").
2. Remove throttle rod (B) from throttle trigger (C).
3. Remove throttle trigger (C) from inner fan case
(A).
4. Remove bolt (D) with spring washer, two wash-
ers, throttle lever (E) and nut from inner fan case
(A).
5. Inspect throttle rod (B), throttle trigger (C) and
throttle lever (E) for wear, damage or deformation.
Replace as required.
6. Set nut (F) on inner fan case (A).
7. Assemble washer (G), throttle lever (E), washer
(H) and spring washer (J) with bolt (D) on inner fan
case (A).
8. Set throttle trigger (B) on boss (a1) of inner fan
case (A) as shown.
9. Apply lithium grease with boss (a2).
10. Set throttle rod (B) on throttle trigger (C).
11. Reinstall all removed parts.
29