PB-2520
EB252
4-9 Replacing ignition switch
B
C
IGNITION SYSTEM
b1
b2
b3
b4
A
1.Remove ignition module (A).(Refer to 4-6 "Re-
placing ignition module")
NOTE: When replacing ignition switch knob (b2)
and ignition switch (B), begin from step 2. When
replacing entire ignition switch (B) , go to step 4.
2. Remove screw (b1). Remove ignition switch
knob (b2).
3. Apply a drop of thread locking sealant (Loctite
#222, ThreeBond 1342 or equivalent) in the screw
hole (b4) of ignition switch. Assemble switch knob
(b2) and lead terminal (b3) with screw (b1).
4. Install ignition switch (B) on inner fan case (C).
Install each lead in ribs of inner fan case as shown.
25