emmeti N CTA W Manual page 10

5. If the time slots do not correspond to the desired schedule, it
is possible to change them manually by proceeding as follows:
select the pre-set time slot which mostly fits the required time
schedule.
For every time interval (each dash corresponds to a half hour) set
the operating mode by pressing one of the following buttons:
Comfort mode:
Press the '
Off / Antifreeze: Press the '
Economy mode: Press the '
Moving the time cursor:
Each time the button which sets the regulation mode is depressed,
the time cursor automatically jumps into the next half hour.
Comfort
Off
Economy
Confirm
6. After programming the schedule for the day or group of days
selected, press the ' OK ' button.
The display will show the program schedule for the next day or
groups of days until the whole week is covered.
7. After programming the schedule for the entire week (repeating
the steps 4 and 5), press the 'OK' button. The chronostat will
memorize the schedule set and the word 'MEMO' will appear
on the display; the device will automatically exit the schedule
programming mode.
' button.
' button.
' button.
Press button ' ' or ' '.
QUICK GUIDE FOR SETTING THE TIME SCHEDULE
• Press button ' P '.
• The display shows ' PrOG ' with the icon '
• Press button ' OK '.
• The display shows ' dAY '
• Press buttons ' ' and ' ' in order to choose one of the four days
combinations available as pre-set.
• Press button ' OK ' to confirm the choice.
• The display shows hour 00:00 with the relevant dash, in the
upside right, flashing.
• Press one of the following buttons to select the temperature
regulation level desired:
Comfort mode:
Off / Antifreeze:
Economy mode:
Moving the time cursor: Press button '
Each time the button which sets the regulation mode is depressed,
the time cursor automatically jumps into the next half hour.
• Once the time schedule for the day or group of days selected has
been set, press button ' OK '.
The display will show the time schedule for the next day or group
of days until the whole week has been covered.
• Once the time schedule for the whole week has been set, press
button ' OK '. The chronostat will store the program into its
memory and the word ' MEMO ' is shown on the display, then it
will automatically quit the time schedule setting procedure.
27
' turned on.
Press the ' ' button.
Press the ' ' button.
Press the ' ' button.
' or ' '.
- ENGLISH -