emmeti N CTA W Manual page 7

WARNING
- To adjust properly room temperature, install the thermostat far from heat sources, airstreams or particularly cold walls (thermal
bridges).
- In order to grant the electrical safety, it is mandatory to screw the chronostat body to the wall mount plate through the two
screws supplied which must be mounted in the battery holder.
- Installation and electrical wirings of this appliance must be made by qualified technicians and in compliance with the current
standards.
- Before wiring the appliance be sure to turn the mains power off.
The device is designed to be installed directly on the wall using the screw anchors provided or in a standard recess (or wall) mounted junction
box with two or three modules.
To install the device carry out the following steps:
1. Release the wall mount plate fitted under the base of the chronostat as shown in Fig. 2.
2. Fix the plate directly on the wall or onto 2 or 3 module junction boxes by means of the two
holes for screws (distance between centres: 60 mm or 85mm), taking care to pass the
wires through the opening as shown in Fig. 3.
3. Make the electrical connections following the connection diagram in Fig. 4.
4. Fit the chronostat onto the wall mount plate, first matching up the teeth on the base with
the holes provided on the plate and then pressing downward on the device until the plastic
teeth of the plate click into place; then fix the chronostat body to the wall mount plate
through the two screws supplied which must be mounted in the battery holder (Fig. 3).
5. Insert the batteries in the battery compartment (O in Fig. 1); see paragraph ' HOW TO
INSERT/REPLACE THE BATTERIES '. Fig. 4
24
REMOTE TELEPHONE
SENSOR INTERFACE
- ENGLISH -