Lixx Storage Program Lixx Storage Program - GRAUPNER ULTRA QUICK 70 Operating Manual

Micro-processor controlled high-performance fast charger for ni-cd / ni-mh, lipo / liio / life batteries

Table of Contents

Available languages

Note: this function is only available for the LiXX battery type.

When LiXX batteries are stored for long periods they must not be in the fully charged or discharged state, as this causes them to lose capacity and may

even ruin them. The STORE charge program should be used to prepare batteries for optimum storage; this charges or discharges the battery until it is

at about 70% of full capacity.

START>1<

LiPo

MODE

START-2 SEC

Charge

START...

Press the MODE  button to move to the STORE menu. A brief press on the CHANGE / START button selects the line showing the final charge voltage

(in this case 4.00 V); the value can be altered using  or . A further brief press of CHANGE / START saves your setting.

B a t t e r y

Setting range

type

LiIon

3.6 - 4.1 V

LiPo

3.7 - 4.2 V

LiFe

3.3 - 3.6 V

Hold CHANGE / START pressed in for at least two seconds to start the storage function. If the voltage of the battery connected to the charger is lower

than the set storage voltage, the charger charges the battery; if the voltage is higher, the charger discharges the battery at the balance current (max. 300

mA) until the set voltage is reached.

15. LiXX storgae program

BATT >1<

SETUP

MODE

Factory setting

3.9 V

4.0 V

3.5 V

STORE ><

USER ><

4.00 V/C