Specification - GRAUPNER ULTRA QUICK 70 Operating Manual

Battery:
Charge currents / power
Ni-Cd & Ni-MH batteries:
Cell count
Lithium batteries :
Cell count
Cell voltage
USB - socket:
General:
Operating voltage range DC input :
Operating voltage range AC input :
Car battery required
Mains PSU required :
Idle current:
Low-voltage cut-off approx .
Balancer connector:
Balancing current:
Safety timer:
Trickle charge:
Weight approx.
Dimensions approx. (WxDxH)
Firmware-Update via Mini USB socket
All data assumes a car battery voltage of 12.5 V.
The stated values are approximate only; they may vary depending on the state of the battery being charged, temperature etc.
1) When powered by a mains PSU, the charger will only operate correctly if the PSU is suitable in terms of voltage, stability, maximum load capacity etc. You can avoid problems by using only the PSUs
which we specifi cally recommend.
38
17. Specifi cation
100 mA to 8 A / max. 50 W with internal power supply 100~240 V AC
100 mA to 8 A / max. 700 W with external 11...15 V DC power
10 battery memories
4 - 10 cells
automatic detection NiCd/NiMH
 peak 3 ~ 20 mV/cell
1-4 cells
3,3V (LiFe), 3,6 V (LiIo), 3,7 V (LiPo)
5 V DC, 500 mA
11.0 to 15 V
100 ~ 240 V
12 V, min. 60 Ah
12 - 14V, min. 12 A stabilised
approx. 100 mA
10.5 V
1...4 LiPo/LiIo/LiFe cells
0.3 A LiPo/LiIo/LiFe
off, 300 min.
0 ~ 250 mA (automatic 1/20 of the preset charge current)
570 g
165 x 140 x 58 mm
1)
Manual ULTRA QUICK 70