Table of Contents
Advertisement
+24VDC Power Connections
motor, host control and any operator interface stations should be in metal
conduits. Use listed push on connectors that are of appropriate size for wire
gauge being used. Connectors are to be installed using crimp tool specified by the
manufacturer of the connector. Only class 1 wiring should be used.
The power supply connections are shown in the Figure 2-4.
Push on
Terminal
Note: Ensure that the power supply has enough power capacity for panel
The panel must always be grounded to protection earth (PE). Grounding helps
limit the effects of noise due to electromagnetic interference on the control system.
Earth connection is made using a push on crimp terminal (Figure 2-4). The
terminal is located near the power supply terminal block. Also connect terminal 3
(Chassis Ground) on the power supply terminal block to ground.
Printer Port
A serial printer can be attached to the Printer Port, Figure 2-8 if port is installed
(not available for KPD007). The communication parameters for the printer are
defined by the application program (project file). The printer port connector is a 15
pin D sub type. Use Baldor RS232 cable, CBL034–501 (9.8 ft, 3m); Gender
Changer, OPT033–501.
Printer Port
HMI Panel
(DCE)
15Pin
MN1272
All interconnection wires between the control, AC power source,
Figure 2-4 Power supply terminal block
Panel
Use
1 2 3
operation.
Figure 2-5 Printer Connections
Null Modem Cable Connections
Frame Ground – 1
RXD – 2
TXD – 3
GND – 5
RTS – 10
CTS – 11
1
2
3
Torque modular connector screws
Modular Connector
to 0.5lb–in (0.6Nm).
2 – RXD
3 – TXD
5 – GND
8 – RTS
7 – CTS
1 – L+ (+24VDC Input)
2 – M (Common L–)
3 –
Chassis Ground
Computer
COM
Port
(DTE)
9 Pin
Receiving & Installation 2-3
Advertisement
Table of Contents
