Table of Contents
Advertisement
CANopen Port
The CANopen Port is a communication port specially designed for CANopen
communication. The CANopen Port connector is a 9 pin D sub type.
The procedure to mount the communication modules is the following:
A
CANopen Port
RS232/485 Port
Table 2-2
Battery Protector
For panels with a battery, be sure to remove the red plastic insulator labeled
"Remove, Battery Protection". This is an insulator that prevents battery depletion
during shipment and storage.
MN1272
1.
Turn off the unit and disconnect input power cable.
2.
Remove the 2 screws ('A' in Figure 2-8) holding the rear cover.
3.
Remove the cover.
4.
Plug the module into the red connectors ('C' in Figure 2-8).
Be sure the connectors are locked.
5.
Install the cover and the 2 screws 'A'.
6.
Install the label shipped with the module in the area 'B' in Figure 2-8.
Figure 2-8
Installing the Communication Module
B
CANopen Port connector and pin assignment
Pin
Description
1
Reserved
2
CAN–
3
Reserved
4
Reserved
5
Shield (RC)
6
Ground
7
CAN+
8
Reserved
9
+5VDC
A
Printer Port
C
Receiving & Installation 2-5
Advertisement
Table of Contents
