Table of Contents
Advertisement
Note: Each time the panel is removed, the gasket should be replaced.
Enclosure
Ç Ç
Gaskets
É É É É É
Ç
É É É É É
Recessed
É É É É É
Area
Panel
2-2 Receiving & Installation
4.
Apply Thick gasket: (Figure 2-1 and Figure 2-2). The gasket should
be applied on the operator panel just behind the bezel. The gasket
should be applied starting from the 1/3 of the lower side being careful to
keep it straight. The two ends of the gasket should meet without
overlap.
Figure 2-2 Mounting the Panel
5.
Secure the panel to the enclosure using the mounting hardware provided
Finger tighten each clamp until all clamps are installed. See Figure 2-3.
Figure 2-3 Panel Hardware
Plastic Shoe
Machine Screw
Clamp
6.
Carefully tighten each clamp until the gaskets are slightly compressed.
Do not overtighten (do not flatten the gaskets).
Cutout
Thin
Gasket
Thick
Gasket
HMI Panel
Recessed
Area
Enclosure
Surface
Recessed
Area
View from
Inside Enclosure
MN1272
Advertisement
Table of Contents
