Carton Contents; Overview; Assembly; Use - Black & Decker GLC120 Instruction Manual

E N G L I S H

CARTON CONTENTS

The carton contains:
1 Cordless grass trimmer
1 Charger
1 Guard with mounting screw
1 Wall mount
2 Mounting screws
2 Wall plugs
1 Instruction manual
Carefully unpack all parts.
OVERVIEW (fig. A)
1. On/off switch
2. Lock-off button
3. Battery housing
4. Secondary handle
5. Handle knob
6. Head release knob
7. Motor housing
8. Guard
9. Line trimming blade
10. Edge guide
11. Spool
12. Cutting line
13. Charger
14. Wall mount

ASSEMBLY

Avoid accidentally switching the tool on
during assembly.
Fitting the guard (fig. B)
Remove the screw (15) from the guard (8).
Place the guard onto the tool as shown.
Firmly press the guard until it snaps into place.
Secure the guard with the screw (15).
Never use the tool unless the guard is
properly fitted.
Mounting the wall mount to the wall (fig. C)
The wall mount (14) is used to provide a convenient
storage and charging point for the tool.
12
Find a suitable indoor location for the wall
mount. If you also want to charge the battery
on the wall mount, this location must be dry
and well ventilated.
Position the wall mount as shown and mark the
location of the two mounting holes (16) on the
wall. Make sure that there is sufficient space to
hang the tool on the wall mount.
Drill a hole (ø 6 mm, approx. 35 mm deep) at
each of the marked locations.
Insert the plugs (17) provided into the holes.
If you do not want to use the wall mount
location for charging the battery, remove the
charging insert from the wall mount.
If you want to use the wall mount location for
charging the battery:
- Guide the cable (19) through one of the slots
(20) as shown.
- Plug the charger (13) into a mains outlet.
Mount the wall mount to the wall using the
screws (18) provided.
Fitting the secondary handle (fig. D)
Unscrew the handle knob (5).
Set the handle onto the tool as shown.
Fasten the handle using the handle knob and
screw as shown.

USE

Let the tool work at its own pace.
Do not overload.
Charging the battery (fig. G & H)
The battery needs to be charged before first use
and whenever it fails to produce sufficient power
on jobs that were easily done before. To maximise
the lifetime of the battery, it is recommended to
keep the battery connected to the charger
whenever the tool is not in use. When the battery
is full, the power consumption of the charger is
negligible.
Do not charge the battery at ambient
temperatures below 5 °C or above 40 °C.
Recommended charging temperature:
approx. 24 °C.